dee2er's Profile
Write a PM to dee2erStatistics
Member Since: 23 Jul 2012Last Seen: 07 Mar 2016
1 Uploads Total
4 Comments By dee2er
Bookmarks
No Bookmarks Yet..
dee2ers latest comments
1-4 out of 4 comments
07 Sep 2012 comment on King 55 - UFS mod
Yeah, without the extra mounting screws the sole felt dangerously flexable. I had indended to do four in each heel but I didn't have enough hardware. The screw either side of the frame plus the UFS bolt form the points of a triangle and it feels good and solid. I may eventually add another couple of screws though, it couldn't hurt.
Yeah, without the extra mounting screws the sole felt dangerously flexable. I had indended to do four in each heel but I didn't have enough hardware. The screw either side of the frame plus the UFS bolt form the points of a triangle and it feels good and solid. I may eventually add another couple of screws though, it couldn't hurt.
26 Jul 2012 comment on King 55 - UFS mod
Thanks. They've taken quite a bit of effort but luckily haven't cost anywhere near the original cost of the boot.
Back in the day whenever I would go to buy some Fatty Pro I'd always wind up leaving the store with Roces...
Thanks. They've taken quite a bit of effort but luckily haven't cost anywhere near the original cost of the boot.
Back in the day whenever I would go to buy some Fatty Pro I'd always wind up leaving the store with Roces...
If you still have the stock frames and wheels in decent condition I'd skate them like that first. Stock Face 60's flat rockered up in the stock frame is a wonderful combo (and prob sits lower than Aeons on 60s).
I'm happy to help out with advice should you want to mod them though. There's a fantastic thread on be-mag forums about flattening out the stock healcup to fit to carbon souls (I used a different healcup but the same technique except I didn't grind down the soul plates just added extra screws for stability). Were I to do this mod again now I would use different soul plates. The carbon souls look awesome but slow down quickly, now I'd try Xsjado 2.0, Seba or Symetrics souls before using Carbon ones again.
The other major change I'd make doing this mod now would be some extra screws holding the front of the boot to the soul plate as well as the UFS bolt as they would have stayed stable longer (at least I think so), sort of like Adapts 6 mount system I guess.